EPadLink ePad Vision Guía de usuario descargar pdf (Pagina 13)

ePad Product Family User’s Guide

align in their seats and the edges are secure. You

can run your finger around the edges of the

protective layer to ensure the protective layer is

not out of place.

• Snap bezel back in place.

ePad-i.d. Pro

• Remove bezel by inserting a rigid wire through the

small pin hole in the lower mid section of the

housing and applying direct force to release bezel.

Use fingernail in lower mid window area to lift

bezel up while applying force to the wire.

• Place thumb and finger on protective layer and

squeeze together to release and remove the

protective layer.

• Install new protective layer making sure dovetails

align in their seats.

• Snap bezel back in place.

ePad-vision

• Remove the stylus holder by unscrewing two

screws located on the bottom of the ePad-vision.

• With your fingers and starting from the upper

area, peel off the old protective layer.

• Install new protective layer starting with the

bottom edge, making sure the holes are aligned

and the edges are secure. You can run your finger

around the edges of the protective layer to ensure

the protective layer is not out of place and bubbles

are not formed.

• Replace the stylus holder and replace the screws.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Sin comentarios

EPadLink ePad Vision Guía de usuario Pagina 13